How to find the right tool for terminal lugs or straight through connectors?

The elpress system uses markings on copper connector tubes. By checking KrF or ksf70, it is found that the neck of such tools is engraved with No. 17, which indicates that the operator should use the crimping die with No. 17, such as B17 and 13b17 tb8-17.

Look for the right tool to put 95 mm ²  Ak/as aluminum or aluminum side is crimped on the AICU terminal, that is, on the sleeve of the tool. On as95, that is alu95-r13-p25, this means that if V250 is used, the female p25m and male P25 should be used with the female die base v2521. If a fan-shaped cable is used, R13 represents the circle that will be formed, and then use the following tools: die base v2531, die r13mr, die r13dr, and die base v2540.

Pre insulated terminals and tools use almost only the colors that indicate the connector area.